Selleys Knead IT Underwater 50g

Selleys Knead IT Underwater 50gKnead It Underwater is a hand kneadable, fast setting co-extruded epoxy repair system that can be used for repairing a multitude of things. It is especially suitable for application to damp, wet or underwater substrates. It comes in a handy roll form, with the white hardener encapsulated in the aqua green resin part. The product hardens in 20-30 minutes after mixing, to form a white solid material.FeaturesWill not sag, run or dripEasy to use no messCan be drilled, sawed, sanded, filed, tapped, machined, or painted 1 hour after mixingGood adhesive strengthGood gap filling propertiesHeat resistant to 120C continuously or 140C intermittentlyCan be used under fresh or salt waterWhere can this product be used?For fast and permanent repairs to damp and wet substrates, and even for underwater repairsPatching dings, scratches, cuts, gouges and holes in fibreglass, metal and wooden boat decks and hullsRepair of pipes, fittings, electrical connections, water tanks, tubs, sinks, spas, hot tubs, tanks, pools and leaking gasketsForming custom gasketsIdeal for emergency in-water repairsWhat materials is this product suitable for?GlassCeramicsMasonryMetalTimberFibreglassSome plasticsHow to use?1. Clean surface free of grease, dirt and dust. For best results, roughen bond area prior to cleaning.2. Cut off required amount. Replace disc on remaining portion. To mix, knead with fingers to uniform colour. If mixing is difficult, warm to room temperature. 3. Wear gloves to avoid messing hands.4. Apply to surface to be repaired (within 12 minutes of mixing) and work the material forcefully into the surface applying pressure until adhesion begins to take effect. Mould to shape if required. If material sticks to fingers, use the plastic wrapper to press the material in place.5. For a smooth appearance, remove excess and hand rub with water or a damp cloth before hardening begins.6. After 20-30 minutes, Knead It Underwater will harden and begin to form a strong bond. Allow for longer cure times at lower temperatures.7. After 60 minutes, Knead It Underwater may be drilled, sanded, machined, filed, sawed or painted.8. Wash hands thoroughly with soap and water after use.Limitations:Does not adhere to polyethylene, polypropylene or Teflon (polytetrafluoroethylene).Set time increases at temperatures below 20C.Not recommended for filling joints/cracks subject to movement as the cured product is extremely hard and inflexible.Do not use Knead It Underwater for applications in contact with drinking water.